Product: Figure Setup Tools
Product Code: ds_bn006
DAZ Original: YES
Version Released: June 15, 2009

• Required Products: 2.3.3.89 or higher or DAZ Studio 3.x
• In addition to the standard system requirements for DAZ Studio, these plug-ins are compiled against the 3.x SDK libraries and so requires a compatible version of the DAZ Studio core application. (See Notes.)

• Basic user help is available within each plug-in.
• For the User's Documentation for this plug-in, click here

• This Figure Setup Toolset contains the following plug-ins:
  • CR2 Exporter
  • Joint Editor
  • Morph Loader
  • Skeleton Setup

• Each of the plug-ins in this toolset will install as an individual plug-in with its own un-installer.
• Within 30 days after installing the plug-ins, you will need to enter a serial key for each plug-in during the DAZ Studio start-up to maintain functionality. These serial keys are in your DAZ on-line account once you have purchased the toolset. Entering the serial keys is a one-time event. However, you will be prompted each time you load DAZ Studio to enter the serial key if you have not already done so.

• Build 3.x
  • New in this build: Compiled for DAZ Studio 3.0
  • Fixed Issues: - None
• Known Issues
  • Transparencies and Specular Surface settings change on export of the CR2.
  • Conforming clothing and props attached to the figure are not exported with the figure.

• Build 3.x
  • New in this build: Compiled for DAZ Studio 3.0
  • Fixed Issues: - None
• Known Issues
  • None

• See the Morph Loader Readme

• Build 3.x
  • New in this build: Compiled for DAZ Studio 3.0
  • Fixed Issues: - None
• Known Issues
  • None

DAZ Studio Tutorials

Visit our site for further technical support questions or concerns: http://www.daz3d.com/i.x/support

Thank you and enjoy your new products!

DAZ Productions Technical Support
12637 South 265 West #300
Draper, UT 84020
Phone:(801) 495-1777
FAX:(801) 495-1787
TOLL-FREE 1-800-267-5170

• This plug-in comes with 3 installers: one for DS 2.3.3.89 or higher, one for DS 3.x (32 bits) and one for DS 3.x (64 bits). Use the one that is compatible with the DS version that you are using.