This page exists within the Old ArtZone Wiki section of this site. Read the information presented on the linked page to better understand the significance of this fact.
The Interiors Series
Each of the packs in the Interiors Series is a single room (or other environment) containing all the figures and props in one file. Every scene is self-contained and loads as a single file with everything pre-positioned and ready to use. Lighting is included, and the figures and props are available separately in the library, and can be loaded as extras or used in other scenes.
The basic room module is a 600x600cm room with walls, floor, ceiling as posable body parts which can be switched off/on. By maintaining the same measurements (or multiples of them), it will be possible to fit rooms together, or use walls and doors from one scene with another. All figures and props are built to real-world scale and can be interchanged between scenes, or used with other products made to a similar scale, for example, the Home One Products. As the series grows, the packs will cover as wide a variety of situations as possible.
Interiors #3 - The Cellar
This is the third pack in the Interiors series. An old cellar, ready to load and use, with everything in place. Entry is through the main doorway, or from a set of steps from above. All walls, doors, pipes, cables and other body parts can be switched off/on for easier camera access, and the figure has 47 different materials which can be re-textured. Presets are provided for the main textures - metal, rust, wood and cobwebs.
The cellar is divided into 2 rooms with a old wooden door connecting them, and each room has a naked light bulb, with cable and light-switch. The 3 sets of pipes, (heating, water, gas) can be switched off/on or textured individually. The cables are split into 6 materials and can also be textured/colored separately. The figure loads as a single scene with all props in place. Light sets are included for both artificial light and sunlight.
Props include a barrel, rusty oil drum, calor gas can, hooks and a wooden pallet, plus 2 cobweb props (1 morphing), with 6 cobweb textures. The Cellar is available in 2 separate versions for DAZ Studio and Poser, each one with native geometry and files.
Recommended camera Focal Length 25 - 35mm
When using the sunlight light set, the ceiling body part must be switched on to ensure correct shadows.
You can post tips here
You can post renders here
You can post comments here
Visit our site for further technical support questions or concerns: http://www.daz3d.com//i.x/support
Thank you and enjoy your new products!
DAZ Productions Technical Support
12637 South 265 West #300
Draper, UT 84020