• Required Products: None
  

The Globe of Death is a circus and carnival stunt where stunt riders ride motorcycles inside a mesh sphere ball. It is similar to the Wall of Death, but in this act riders can loop vertically as well as horizontally. The globe of death is produced using several segmented, bowed portions of welded mesh where sections of material are fitted together and riveted. One panel of steel at the bottom of the globe acts as a trap door where riders and their bikes can enter and exit. While there are standards, many groups of riders use their own globes of various sizes. While the 5,300 pound 16 foot globe is most common, some performers use smaller sizes, and even 17 foot globes.

The circus act now known as the Globe of Death first started to appear in 1901 as the cycle whirl, which had slatted vertical columns instead of a complete sphere. First stunt in complete globe was recorde in the years 1903 and 1904. Globe of Death attraction was usually kept covered by a canvas tent so as to compel paid entry.

Below is a list of the installation package types provided by this product. The name of each package contains a Package Qualifier, which is used as a key to indicate something about the contents of that package.

• 1 Core ¹⁾

[ ] = Optional, depending on target application(s)

Not all installation packages provide files that are displayed to the user within the interface of an application. The packages listed below, do. The application(s), and the location(s) within each application, are shown below.

DAZ Studio Folders

• You can find new icons for loading this product in the following DAZ Studio Folders:
  • ./Environments/Architecture/Cybertenko/DareDevil Stunts/Globe of Death

DAZ Studio Categories

• You can find new icons for this product in the following DAZ Studio Categories:
  • Environments » Architecture » Exterior
  • Environments » Architecture » Interior
  • Props » Architecture
  • Props » Landscape » Ground

• File List

• None

• None