Table of Contents
|Product Name:||Polar Bear dForce Pillow|
|Published Artist(s):||Cris Palomino|
Get your characters comfy with this dForce Polar Bear pillow.
A Scene Subset is provided to load the bear pillow with four geoshells which build up the fuzziness. Two dForce presets for soft and softer plus a second soft variation with a slightly higher Contraction/Expansion setting.
Material settings for Iray textures for the base bear pillow and each of the geoshells.
Turn off “Start Bones from Memorized Pose” to avoid starting from the Figure's default pose (T or A pose). You will likely want to set “Frames to Simulate” set to “Animated (Use Timeline Play Range)”.
Lift the bear pillow slightly off the surface upon which you want it to land to simulate. You can add a plane or use an environment set's floor or other primitive.
If you experience any problems rendering and suspect it is the number of GeoShells, you can control their visibility in the Scene tab.
Keep figure's body from starting the simulation with any part inside the pillow. You want the figure to push down or into the pillow as it simulates. Watch Mada's informative video for more info.
This, and other posts, in this Daz Forums thread can provide information and experimentation that you may find helpful. https://www.daz3d.com/forums/discussion/comment/4086371/#Comment_4086371 Happy holidays.
Below is a list of the installation package types provided by this product. The name of each package contains a Package Qualifier (WIP), which is used as a key to indicate something about the contents of that package.
Not all installation packages provide files that are displayed to the user within the interface of an application. The packages listed below, do. The application(s), and the location(s) within each application, are shown below.
Visit our site for technical support questions or concerns.